<< back

Step 1
Use an Ethernet cable here to connect your PAP2 to your router or Internet connection.

Step 2
Connect the power cord adapter to your PAP2. The front LEDs will light up and begin to blink. Blinking may continue for approximately 5 minutes, during this time the PAP2 communicates with our network and checks for any updates.

Step 3
After the LEDs have stopped blinking, plug in a standard telephone into port #1 of your PAP2 device and check for a dial tone.*

Congratulations, you are now ready to use your account!

*If you do not hear a dial tone at this point, or if you only hear a busy signal, please contact Customer Service at 1-888-868-8318 for further assistance. Alternatively, you may also refer to the included CD-ROM for basic PAP2 troubleshooting instructions.